Re-assembly Activities A word of CAUTION: The through-tube size used in the LeLure Globe is not consistent. I recommend that you insert the through-wire into the globe head to make sure that the head spins freely. If it does not, you will need to use a smaller through-wire. Using the pre-bent globe shaft, slip a cup washer on to the shaft and then slide the shaft through the globe head. Now place a cup washer onto the shaft between the globe head and the globe body...this will allow the globe head to spin freely. If your globe has a metal clip or swivel that should be attached to the globe shaft, now is the time to position it into the globe body as you insert the shaft into the globe body. Now that the shaft is inserted into the globe body, you need to make a circle bend in the shaft protruding from the rear of the globe...there should be about 1½ inches of shaft protruding from the rear of the globe. Before closing the rear loop, slide a split ring onto the shaft as shown above.
RkJQdWJsaXNoZXIy ODA4MA==